Viqua Lamp & Sleeve Combo Kit for UVMax Model A - #602809-100
Trojan UVMax Lamp & Sleeve Combo - #602809-100 | The Trojan UVMax Lamp & Sleeve Combo - #602809-100 has been discontinued by the manufacturer. |
Guaranteed Genuine Trojan UVMax #602809-100 Lamp & Sleeve Combo. Don't be Fooled by Knock-Offs!
- Description
- Specifications
- Related Products
- Installation / Manual
- Reviews
- FAQ
- Why Genuine
We are pleased to offer a complete selection of replacement lamps & sleeves for all Viqua / Sterilight ultraviolet (UV) sterilizers. Viqua / Sterilight replacement lamp & sleeve combo kits are designed only for use in Viqua / Sterilight UV sterilizers.
Trojan UVMax #602809-100 is the replacement lamp & sleeve combo for the following models:
- Viqua UVMax Model A
Trojan UVMax #602809-100 Specifications
| Technical Specifications | |
|---|---|
| Part # | #602809-100 |
| Lamp | Trojan UVMax #602803 |
| Sleeve | Trojan UVMax #602730 |
| Lamp Length | 12" (30cm) |
| Lamp Power | 14 Watts |
| Lamp Life | 12 Months |
How to change a UVMax #602803 Lamp
- Turn off water supply valve to UV sterilizer
- Turn on faucet elsewhere in the home to depressurize the system
- Disconnect your UV system from power (unplug unit)
- Allow system to cool for 5 - 10 minutes
- Put on clean gloves
- Remove dust cover by squeezing and lifting up
- Lift lamp connector straight up
- Remove UVMax #602803 lamp from system by unscrewing and lifting straight up
- Insert new UVMax #602803 lamp into the system
- Screw new UVMax #602803 lamp into the system
- Push lamp connector down onto chamber
- Attach dust cover and slide over top of chamber
- Plug in UV system
- System will beep
- Hold reset button until system beeps and counter is reset to 365
- Slowly open water supply valve to UV sterilizer
- Check for leaks
- Close faucet elsewhere in the home
Trojan UVMax Lamp & Sleeve Combo - #602809-100 Reviews
.There are currently no reviews for this product.
Be the first to write a review.
Trojan UVMax Lamp & Sleeve Combo - #602809-100 Customer Questions & Answers
It is critical that only genuine Viqua brand original equipment lamps be used in your system. It has come to our attention that a number of Chinese manufacturers are making knock-off replica UV lamps. While they may physically fit in a Viqua system, they are NOT compatible. Testing of a wide range of these lamps has shown that many do not provide a safe UV dose or offer protection for the stated lamp life, and in some cases have even caused the failure of the ballast/controller and melting of the lamp harness.
