Enpress CT-COMM05-MB Melt-Blown Commercial Sediment Filter - 5 Micron
5 micron melt-blown polypropylene commercial sediment filter for Enpress ONE Cartridge Tank systems
Enpress CT-COMM05-MB Cartridge
Our Price: US$149.00
You save: $38.00
Write a review.
Found a Lower Price?
Request a Price Beat
Lowest Price Guaranteed!If you find a lower price on this product call us or Click here to request a price beat.
Alternative Part Numbers:
The CT-COMM05-MB is a 5 micron melt-blown commercial sediment filter designed for extended service life and high flow rates. The CT-COMM05-MB is acceptable for flow rates up to 100 GPM. See the pressure drop vs. flow rate chart for expected pressure loss at various flow rates.
The CT-COMM05-MB will outperform competitive filtration solutions in all turbidity applications including silt, rust, and other soft particle filtration. The Purple Series also provides lower shear water velocity as the raw water passes through the filter, allowing for more contact time and interaction with the extensive surface area of the filters. This results in higher water quality and longer life of the filtration system.
Each filter comes with top cap with built-in handle for lightweight and easy removal, a bag for proper sanitary disposal, and a double o-ring bottom seal to prevent filter bypass.
All components and materials are manufactured from NSF 61 and FDA certified materials.
The Enpress CT-COMM05-MB cartridge is designed specifically for Enpress ONE Cartridge Tank filter systems with 2 inch inlet/outlet. The Enpress ONE Cartridge Tank is marketed under a variety of other brand names and part numbers, including: Watts SCT-200; Water-Right EF-835-2 and EF-840-2; Hellenbrand 109711, and Nelsen NFS-HF-PLUS. This cartridge is compatible with all of these systems that have a 2 inch inlet/outlet.
Features and Benefits:
- Improved service life, contaminant removal, and dirt holding capacity
- Large surface area to promote high flow rates, low pressure loss, and reduced cartridge replacement frequency
- Double EPDM o-ring seals to ensure no bypass of contaminants and high chemical compatibility
- Durable polypropylene construction for superior bacteria and chemical resistance
|Filter Type:||Melt Blown Polypropylene|
|Micron Rating:||5 Microns (Nominal)|
|Max. Recommended Flow Rate:||100 GPM (380 LPM)|
|End Cap Material:||Polypropylene|
|Max Pressure (Feed):||150 psi (<90 psi recommended)|
|Max. Pressure Differential:||30 psi|