Sterilight S212ROL Lamp

Sterilight S212ROL Lamp

MSRP: US$93.00
Our Price: US$59.20
You save: $33.80

- or -
Make us an offer for the Sterilight S212ROL Lamp

(0 Reviews)
Be the first to write a review.

Found a Lower Price?
Request a Price Beat
Free Shipping on orders over $79

Lowest Price Guaranteed on the Sterilight S212ROL Lamp

Guaranteed Genuine Sterilight S212ROL Original Equipment Lamp. Don't be Fooled by Knock-Offs!

Sterilight S212ROL Lamp

  • Description
  • Specifications
  • Related Products
  • Installation / Manual
  • Reviews
  • Why Genuine

We are pleased to offer a complete selection of replacement lamps for all Sterilight ultraviolet (UV) sterilizers.

This 185 nm wavelength UV lamp is designed for ozone generation. It should not be used for disinfection.

Sterilight S212ROL replacement lamps are designed only for use in Sterilight UV sterilizers. We do not recommend that you attempt to use Sterilight replacement lamps in models made by other manufacturers.

Sterilight S212ROL is a retrofit lamp for the following models:

  • Sterilight SQ-PA (for TOC reduction)

Sterilight S212ROL Specifications

Technical Specifications
Application TOC Recduction
Part # S212ROL
Wavelength 185nm
Length 8.3" (21 cm)

Replacement Sleeve

Replacement Sleeve <br>Part#:QS-212

MSRP: US$37.00
Our Price: US$29.00
You save: $8

- More Info -

How to change a Sterilight S212ROL Lamp

  1. Turn off water supply valve to UV sterilizer
  2. Turn on faucet elsewhere in the home to depressurize the system
  3. Disconnect your UV system from power (unplug unit)
  4. Allow system to cool for 5 - 10 minutes
  5. Put on clean gloves
  6. Squeeze tabs on lamp connector and lift straight up
  7. Disconnect lamp connector from Sterilight S212ROL lamp
  8. Remove Sterilight S212ROL lamp from system
  9. Insert new Sterilight S212ROL lamp into the system
  10. Line up longest pin on lamp to shortest pin on lamp connector
  11. Once the Sterilight S212ROL lamp and lamp connector are attached slide assembly down towards chamber until you hear a click & it is attached
  12. Hold down reset button on side of power supply to reset day counter & plug in UV system
  13. Screen will display RSET
  14. Slowly open water supply valve to UV sterilizer
  15. Check for leaks
  16. Close faucet elsewhere in the home
Note: The Sterilight Sterilight S212ROL is a fluorescent lamp and can be recycled at most hardware stores or your local hazardous waste facility.

Sterilight S212ROL Lamp Reviews

There are currently no reviews for this product.
Be the first to write a review.
It is critical that only genuine Viqua brand original equipment lamps be used in your system. It has come to our attention that a number of Chinese manufacturers are making knock-off replica UV lamps. While they may physically fit in a Viqua system, they are NOT compatible. Testing of a wide range of these lamps has shown that many do not provide a safe UV dose or offer protection for the stated lamp life, and in some cases have even caused the failure of the ballast/controller and melting of the lamp harness.