Filter-Ag® (Part #A8014)
Clack Filter-Ag (#A8014)
Our Price: US$103.00
You save: $26.00
Bulk quantity discounts available.
For bulk quantities, please call 1-866-376-2690 for quote.
Write a review.
Found a Lower Price?
Request a Price Beat
economical light-weight media for the reduction of sediment and turbidity - filtration to 20-40 microns
Filter-Ag's® highly fractured edges and irregular surfaces provide a high surface area and complex flow path for efficient removal of suspended matter throughout the filter bed, typically reducing suspended solids down to the 20-40 micron range. Filter-Ag's® larger particle size creates less pressure loss and allows deeper particle penetration into the bed for greater sediment loading and extended filter run cycles. .
Filter-Ag's® relatively light weight allows for lower backwash flow rates and better bed expansion to release trapped sediment during backwash.
Filter-Ag® can be used in both pressure or gravity flow systems. It can also be used as a layer in multi-media filter designs allowing a more flexible approach to difficult filtration problems.
- low pressure loss
- relatively low backwash flow rates
- light weight
- ANSI/NSF 61 validated
|Operating Conditions / Requirements:|
|Service Flow Rate:||5 GPM/ft2|
|Flow Direction:||Downward Flow|
|Typical Pressure Drop:||<1 psi|
|Backwash Flow Rate:||8-10 GPM/ft2|
|Backwash Bed Expansion:||20-40%|
|Minimum Bed Depth:||24 Inches|
|Recommended Bed Depth:||30 to 36 Inches|
|Maximum Feed Temperature:||140F|
|Recommended pH:||6.5 to 8.5|
|Weight:||25 lbs per Ft3|
|Recommended Configurations for Residential and Light Commercial Applications|
|8 x 44||9 x 48||10 x 54||12 x 52||13 x 54||14 x 65||16 x 65|
Flow Rate (GPM):
|1.7 to 2.4||2.2 to 3.1||2.7 to 3.8||3.9 to 5.5||4.6 to 6.5||5.3 to 7.5||7.0 to 9.8|
|Backwash Flow Rate
@ 40F (GPM):
|Backwash Flow Rate
@ 70F (GPM):
Filter-Ag® is a registered trademark of Clack Corporation.