CAD / USD
CART
1-866-376-2690
SoftPlus Water Softeners Iron Rival Iron Reduction Systems ecoTAC Hard Water Conditioning Systems

Dow Filmtec LE-400 Reverse Osmosis (RO) Membrane

11,5000 GPD industrial / commercial low energy replacement reverse osmosis (RO) membrane element

The Filmtec LE-400 element is a low-energy element for industrial and municipal applications that operates at low pressure to deliver energy savings in new equipment or replacement situations where energy cost is an important factor and unit price is a key driver.

  • Delivers equivalent permeate flow at 40% lower feed pressure, compared to the Filmtec BW30-400.
  • Offers the proven performance and high productivity of the Filmtec BW30-400 element construction, with lower energy use and operating expense.
  • The new Filmtec LE-400 has an industry standard 1.125 inch ID permeate tube to facilitate element replacement.
Specifications:
Membrane Type:Polyamide Thin-Film Composite (TFC)
Maximum Operating Temperature:113F (45C)
Maximum Operating Pressure:600 psi (41 bar)
Maximum Pressure Drop:15 psi (1.0 bar)
Maximum Feed Flow Rate:85 gpm (19 m3/hr)
pH Range, Continuous Operation:2-11***
pH Range, Short-Term Cleaning:1-13* (30min)
Maximum Feed Silt Density Index:5 SDI
Free Chlorine Tolerance:<0.1 ppm**
Permeate Flow Rate:11,500 GPD (44 m3/day)*
Stabilized Salt Rejection:99.3%
Filmtec LE-400 Reverse Osmosis (RO) Membrane

*Permeate flow and salt rejection based on the following standard conditions: 2,000 ppm NaCl, 150 psi (10.3 bar), 77F (25C), pH 8 and 15% recovery. For comparison, the LE-400 will have a permeate flow of 12,200 gpd (46 m3/d) and stabilized salt rejection of 99.3% when normalized to a feed solution of 1,500 ppm NaCl as used by some manufacturers. Flow rates for individual elements may vary but will be no more than 15% below the value shown.

**Under certain conditions, the presence of free chlorine and other oxidizing agents will cause premature membrane failure. Since oxidation damage is not covered under warranty, Dow recommends removing residual free chlorine by pretreatment prior to membrane exposure. Most RO systems have carbon pre-filters for this purpose.

***Maximum temperature for continuous operation above pH 10 is 95F (35C).

Note: Active surface area guaranteed +/-3%. Active area as stated by Filmtec is not comparable to nominal membrane area often stated by some manufacturers.

Dimensions:

   A: 40.0" (1,016mm)
   B: 1.125"ID (29mm)
   C: 7.9" (201mm)
Filmtec LE-400 Size Chart
Model Diameter Inches Length Inches Active Surface
Area ft2 (m2)
Test Pressure Permeate Flow
Capacity
GPD (m3/day)
Price
(w/ Free Shipping)
Filmtec LE-400
Our Stock #703249109
Dow Part #249109
8.0 40 400 (37) 150 psi 11,500 (44)

Notice: The use of this product in and of itself does not necessarily guarantee the removal of cysts and pathogens from water. Effective cyst and pathogen reduction is dependent on the complete system design and on the operation and maintenance of the system.

Customer Questions & Answers


No customer questions have been submitted for this. Have a question? Ask it above.